Panasonic NV-GS90 Operating Instructions Manual page 43

5: The movie camera cannot be operated
though powered up.
The movie camera does not operate
normally.
• The movie camera cannot be operated unless
you open the LCD monitor or extend the
viewfinder.
• Remove the cassette and then press the
[RESET] button. (
-44-
not restored yet, turn off the power. Then,
about 1 minute later, turn on the power again.
6: The cassette cannot be removed.
• Does the status indicator comes on when
opening the cassette cover? (
that the battery and the AC adaptor are
properly connected. (
• Is the battery in use discharged? Charge the
battery and remove the cassette.
• Close the cassette cover completely, and fully
open it again. ( )
-13-
7: No operation other than cassette removal
can be performed.
• Has condensation occurred? Wait until the
condensation indication disappears. (
Recording
1: Recording does not start although power is
supplied to the movie camera and the
cassette is correctly inserted.
• Is the accidental erasure prevention slider on
the cassette open? If it is open (set to [SAVE]),
recording cannot be performed. (
• Is the tape wound to the end? Insert a new
cassette.
• Is the recording mode set? When in the
playback mode, recording cannot be
performed. ( )
-9-
• Has condensation occurred? No operation
other than cassette removal can be performed
when condensation occurs. Wait until the
condensation indication disappears. (
• Is the cassette cover open? If the cover is
open, the movie camera may not operate
normally. Close the cassette cover. (
2: The screen has changed suddenly.
• Has the demonstration started? In the Tape
Recording mode, if you set [DEMO MODE] >>
[ON] without inserting a cassette, the
demonstration starts. For normal use, set this
function to [OFF]. (
3: A cassette cannot be inserted.
• Has condensation occurred? Wait until the
condensation indication disappears.
) If normal conditions are
) Make sure
-13-
)
-8-
-45-
)
-14-
-45-
-13-
)
-39-
Others
4: Auto focus function does not work.
• Is manual focus mode selected? If auto focus
mode is selected, focus is automatically
adjusted.
• There are some recording subjects and
surroundings for which the auto focus does not
operate correctly. (
focus mode to adjust the focus. (
Indications
1: A sentence is displayed in red in the screen
centre.
• Read the contents and respond to them. (
2: The remaining tape time indication
disappears.
• The remaining tape time indication may
disappear temporarily during frame-by-frame
playback or other operation. If you continue
ordinary recording or playback, the indication is
restored.
3: The remaining tape time Indication does not
match the actual remaining tape time.
• If scenes of less than 15 seconds are
)
continuously recorded, the remaining tape time
cannot be correctly displayed.
• In some cases, the remaining tape time
indication may show remaining tape time that is
2 to 3 minutes shorter than the actual
remaining tape time.
4: A function indication such as mode
indication, remaining tape time indication,
or time code indication is not shown.
• If you set [SETUP] >> [DISPLAY] >> [OFF],
indications other than the tape running
condition, warning, and date indications
disappear.
5: "CHECK THE LENS COVER." is displayed.
• Open the lens cover before turning the unit on.
• This message may appear if you try to record in
extremely dark places.
)
)
) If so, use the manual
-49-
)
-29-
)
-41-
43
LSQT1290