Sound Settings - Pioneer SX-20DAB-K Operating Instructions Manual

04 Operation
1 Press the FM/DAB button repeatedly to
select "DAB".
DAB
Station name
BBC
News
Using the auto scan function manually
Using DAB for the very first time
The very first time you use DAB, press the SCAN button
to run the Auto Scan.
If a new DAB station is introduced, or you move to a new
area, you can run the Auto Scan function again.
1 Select DAB.
See Selecting DAB above for more on this.
2 Press the SCAN button.
DAB
Sc a n n ing.. .
Selecting DAB stations
1 Select DAB.
See Selecting DAB above for more on this.
Press the TUNE / button to select a
2
DAB service.
BBC
<BBC5Live>
3 Press the ENTER button to listen to the
service.
The station is tuned.While the primary service is
selected, brackets < > are displayed. While the
secondary service is selected, brackets ( ) are displayed.
BBC
(BBC5Live)
12
En
If you select a station that cannot be received properly,
"DAB No Tuned" is displayed.
DAB
No Tuned
Displaying DAB radio information
1 Select DAB.
See Selecting DAB above for more on this.
2 Press the RDS DISPLAY repeatedly to
display information about the selected DAB
station.
Program Type
Displays the type of program.
BBC
News
SNR (Signal Noise Rate)
Noise may be generated and reception quality may
become poor according to Signal Noise Rate. If
reception quality is poor, move the antenna in different
directions to find a position where the good rate is
displayed.
BBC
SNR:100
DLS (Dynamic Label Segment)
When tuned to a station which is broadcasting DLS text
data, the text will scroll across the display.
BBC
All the late
Scroll
Audio Mode
Displays the audio mode (stereo or mono).
BBC
DAB Stereo
Frequency
Displays the frequency of the current multiplex.
BBC
FREQ:239.200MHz
Multiplex Name
Displays the name of the current multiplex.
BBC
BBC Station
Bitrate
Displays the bit rate.
BBC
BITRATE:192kbps
DAB setup
1 Press the TOP MENU button.
Press / to select the item to be set,
2
then press the ENTER button.
The following settings are available for DAB.
DRC
The DRC (Dynamic Range Control) function lets you
change the dynamic range of the received sound
depending on the content of the broadcast so that the
sound is easier to hear even when the volume is low.
Press the / button to select the following options,
and then press the ENTER button.
DRC:Off : DRC is switched off.
Any DRC level broadcast will be ignored. This is the
default setting.
DRC:On : Applies DRC level as sent with the broadcast.
Component Reset
Deletes all the stations.
While Reset: Yes? appears, press the ENTER button.
" "

Sound settings

Adjusting the bass and treble
Use the bass and treble controls to adjust the overall
tone.
1 Use BASS +/– or TREBLE +/– on the
remote control to adjust bass or treble.
FM MODE MEMORY BALANCE
L R
BASS TREBLE
NETWORK AUDIO PLAYER
SACD PLAYER
FUNC
Note
• You can also use the front panel controls. Press
TONE repeatedly to select BASS or TREBLE, then
press /– or +/ to adjust the bass or treble as
desired.
Adjusting the sound volume balance
Adjust the sound volume balance between the left and
right speakers.
1 Press BALANCE then press L/R to adjust
the sound volume balance.
FM/DAB RETURN
FM MODE MEMORY BALANCE
L R
BASS TREBLE
Note
• You can also use the front panel controls. Press
BALANCE to enter balance mode, then use /– or
+/ to adjust the balance.