Table of Contents
Advertisement
Connecting an antenna or cable TV (no box)
Antenna or cable TV
On your TV
Coaxial cable
connector
ANT/CABLE IN
jack
1 Make sure that your TV's power cord is unplugged and all connected devices are turned off.
2 Connect a coaxial cable (not provided) to the ANT/CABLE IN jack on your TV and to the antenna or cable TV wall
jack.
3 Plug your TV's power cord into a power outlet, then turn on your TV.
4 Press INPUT to open the INPUT SOURCE list.
5 Press
or
to highlight TV, then press ENTER.
6 If you cannot tune to channels you know exist, scan for channels. See
page 42.
Notes
• Use a coaxial cable to eliminate interference and noise from radio waves.
• Do not bundle the coaxial cable with the power cord or other cables.
• If the antenna is not installed correctly, contact qualified service personnel to correct the problem.
• If the signal level for a channel is weak, the picture may be distorted. Adjust the antenna or use a
highly directional outdoor or set-top antenna with a built-in amplifier.
• If the picture quality is good on some channels and poor on others, the problem may be caused by
a poor or weak signal from the broadcaster or cable TV provider.
• If you connect to cable TV without a set-top box and experience poor picture quality, you may
need to install a set-top box to improve signal reception and picture quality. Contact your cable TV
provider about upgrading to a set-top box.
• Many high-definition (HD) channels upscale standard-definition (SD) content. The picture
displayed on your TV is still displayed as SD, thus the picture quality will not be as clear or crisp as it
would be if the content was originally recorded in HD.
15
(no box)
Coaxial cable
www.insigniaproducts.com
Side of TV
Automatically scanning for channels
48"/55" 1080p 60Hz LED TV
on
Hide quick links:
Advertisement
Table of Contents
