NordicTrack NTC07940 User Manual page 9

INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR
If you purchase the optional chest pulse sensor (see page 21), follow the steps below to install the receiver
included with the chest pulse sensor.
Remove the access door from the underside of the
Console (4). You may need to use a small standard
screwdriver to remove the access door.
Access
Door
Slide the receiver onto the indicated plastic pin on the
4
Console (4); make sure that the receiver is oriented
exactly as shown. Locate the two small screws included
with the chest pulse sensor. Attach the receiver to the
Console with the two screws as shown.
Pin
Connect the wire on the receiver to the indicated wire on
the Console (4).
Wire
Reattach the access door. Make sure that no wires are
Receiver
pinched. Note: The other wires included with the chest
Screws
pulse sensor may be discarded.
9