Connect Power; Get Started; Prepare The Remote Control - Philips FWD410 User Manual

Connect power

Caution
•
Risk of product damage! Make sure that the power
supply voltage corresponds to the voltage printed on
the back or the underside of the unit.
•
Before connecting the AC power cord, make sure that
you have completed all other connections.
• Connect the AC power cord to
• the AC MAINS~ socket on this unit.
• the wall power socket.
EN
14
FWD410_UM_98_EN_V2.0.indd 14

4 Get started

Caution
•
Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
back of the apparatus. Write the numbers here:
Model No. __________________________
Serial No. ___________________________

Prepare the remote control

1
Press and push the battery compartment
to slide it open (see "1" in the illustration).
2
Insert two AAA batteries with correct
polarity (+/-) as indicated.
3
Push and slide back the battery
compartment (see "3" in the illustration).
Note
•
The batteries shall not be exposed to excessive heat
such as sunshine, fire or the like.
•
If you are not going to use the remote control for a
long time, remove the batteries.
•
Do not mix batteries (old and new or carbon and
alkaline, etc.).
•
Batteries contain chemical substances, so they should
be disposed of properly.
11/29/2013 4:15:52 PM