Nokia TransACT N91 8GB Owner's Manual page 106

Wireless LAN
Follow the instructions from your service provider.
WLAN netw. name—Select
for netw.. If you select an existing network,
mode and WLAN security mode
settings of its access point device.
WLAN netw. mode—Select
network and to allow devices to send and receive data
directly; a wireless LAN access point device is not needed.
WLAN security
802.1x (not for ad hoc networks), or WPA/WPA2. If you
select Open network, no encryption is used. The WEP,
802.1x, and WPA functions can be used only if the
network supports them.
WLAN security
security mode:
Security settings for WEP:
Wep key in use—Select the WEP key number. You can
create up to four WEP keys. The same settings must be
entered on the wireless LAN access point device.
Authentication
authentication type between your device and the wireless
LAN access point device.
106 Copyright © 2006 Nokia. All rights reserved.
Enter manually
are determined by the
Ad-hoc to create an ad-hoc
mode—Select the encryption used: WEP,
sett.—Enter the settings for the selected
type—Select Open or Shared
WEP key
key), WEP key format (ASCII
key (the WEP key data in the selected format).
or Search
Security settings for
WLAN netw.
WPA mode—Select the means of authentication:
use an extensible authentication protocol (EAP) plug-in, or
Pre-shared key
appropriate settings:
EAP plug-in settings
your service provider instructs.
Pre-shared key
password. The same password must be entered on the
wireless LAN access point device.
TKIP encryption—Select whether Temporal Key Integrity
Protocol (TKIP) is used.
Homepage—Define a home page.
Select Options
following:
IPv4 settings:
device), Subnet mask
for the gateway (the gateway), and
addresses of the primary and secondary DNS server.
Contact your Internet service provider for these addresses.
settings—Enter WEP encryption
or Hexadecimal), and
802.1x and WPA/WPA2:
to use a password. Complete the
(only for EAP)—Enter the settings as
(only for Pre-shared
> Advanced settings
Phone IP address (the IP address of your
(the subnet IP address),
DNS address—enter the IP
(length of the
WEP
EAP to
key)—Enter a
and from the
Default