Honeywell Intelliguard 9000 Installation Instructions Manual page 11

— When both buttons on the BIC-2 or BIC-2 HU are
pressed simultaneously, an alarm signal is sent to
the I9000 Security System. How the I9000
Security System interprets the alarm depends on
the I9000 programming for input 4 on each BIC-2
or BIC-2 HU. Input 4 of BIC-2 HUs are normally
Sometimes it is more convenient and less expensive to have detection devices connected to a 2-Input Concentrator (BIC-2).
Each BIC-2 or BIC-2 HU accepts a maximum of two inputs and provides one output. Each I9000 CU controls a maximum of 31
BIC-2 or BIC-2 HU devices on each COM for a total of 62. See Fig. 12.
1
INPUT INPUT
EOLR EOLR
+ –
CU COM
Fig. 11. Internal view of BIC-2, BIC-2 HU wiring terminals, mounting holes.
NOTE: COM and VDD connect to 12 Vdc. TXRX- and TXRX+ connect to CU COM 1 or 2, but not both. LP1 and LP2 connect to
input points.
BIC-2 UNIT ASSEMBLY
(BEIGE BUTTONS) 8003-242
BIC-2 HU UNIT ASSEMBLY
(RED BUTTONS) 8003-284
NOTE: Press both actuator buttons simultaneously to generate an alarm signal.
BIC-2 AND BIC-2 HU P.C.B.
ASSEMBLY 8003-241
1
COM LED
MOUNTING
HOLES (3)
K1
OUTPUT
1
K1
2
W1
3
1 4
U4
TB1
8 O/C (OPEN COLLECTOR)
7 LP2 +
6 LP1 & 2
5 LP1 +
4 TxRx +
3
TxRx –
2 VDD
1 COM
+ –
12 VDC
ACTUATOR BUTTONS
(ONE ON EACH SIDE)
COM LED IS VISIBLE THROUGH
RIGHT SIDE ACTUATOR BUTTON
Fig. 12. BIC-2, BIC-2 HU cover removal.
defined as Type 7 (Hold-up 24 hours) or 8 (Hold-
up 12 hours, day only). Input 4 of BIC-2s may be
defined as any recognized type other then Type 7
and 8. Each CU supports a maximum of 31
devices (any combination of BIC-2s and/or BIC-2
HUs on each COM, for a total of 62). See Fig. 11.
8
7
6
5
WHEN USING RELAY OPTION, REFER TO BIC-2, BIC-2 HU
1
TWO-ENTRY CONCENTRATOR CONFIGURATION FOR LOOP
TYPES AND EOLRs. (LOOP 2 NOT AVAILABLE USING THIS OPTION.)
2
COM LED IS VISIBLE THROUGH ACTUATOR BUTTON.
ALSO SEE BIC-2, BIC-2 HU DIAGRAM.
11
INTELLIGUARD 9000™
M14490A
LIFT COVER
PUSH
FLAT-BLADED
SCREWDRIVER
M16114A
74-3047—1