Epson Stylus Office T1110 Service Manual page 121

_______________________________________________________________________________________
WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100
6. .Press the Driven Pulley toward the center to loosen the CR Drive Belt, and
remove the CR Drive Belt from the CR Motor Pinion Gear.
CR Drive Belt
Driven Pulley
Figure 4-149. Removing the CR Motor
7. Remove the two C.B. M3 x 4 screws that secure the CR Motor, and remove the CR
Motor from the Main Frame.
Figure 4-150. Removing the CR Motor
_______________________________________________________________________________________
打印机维修论坛 http://www.printerwhy.net/
Disassembly And Assembly
高速行式打印机 http://www.lineprinter.com.cn/
CR Motor Pinion Gear
19) C.B. M3x4
(4±0.5 kgf.cm)
2 1
Make the Lot No. printed surface on the CR Motor face the
direction shown in the figure below.
Tighten the screws in the order shown in
After replacing the CR Motor, always make the required adjustments
A D J U S T M E N T
R E Q U I R E D
referring to the following.
• "Chapter 5
打印机驱动下载 http://www.printerwhy.com/
Removing the Motors
Lot No. Printed Surface
Figure 4-151. Reinstalling the CR Motor
Figure 4-150
Adjustment (p.128)"
Revision A
121
Confidential