Bosch PSR 9,6 VE-2 Operating Instructions Manual page 11

2 609 932 287 - Buch Seite 3 Mittwoch, 22. Oktober 2003 1:58 13
Fully Automatic Spindle Locking
(Auto-Lock)
The drill spindle is locked when the On /Off
switch 4 is not pressed.
This makes quick and easy changing of the tool
in the drill chuck possible.
Reversing the Rotational Direction
Operate the rotational
switch 5 only at a standstill.
The rotational direction
switch 5 is used to re-
verse the rotational direc-
tion of the machine. How-
ever, this is not possible
a b
with the On/Off switch 4
actuated.
a
Right Rotation ( )
Turn the rotational direction switch through to the
left stop (normal operation: drilling, screwdriving,
etc.).
b
Left Rotation ( )
Press the rotational direction switch through to
the right stop (for loosening and unscrewing
screws and nuts).
Setting the Torque
With the correct setting, the clutch disengages as
soon as the screw is driven flush into the material
or the set torque is reached. Select a higher set-
ting when driving out screws, or set to the "Drill-
ing" symbol.
Low setting, e. g., small screws, soft
1
materials.
High setting, e. g., large screws, hard
25
materials.
Drilling
Set the torque setting ring 2 to the "Drill-
ing" symbol.
11 • 2 609 932 287 • 03.10
Cordless Screwdriver Display
The display 10 is activated when the battery 7 is
inserted.
After a while the display switches to the stand-by
mode. The display 10 can be activated again by
inserting the battery 7 or by pressing one of the
two push-button keys on the display.
For temperatures below 0 °C the function of the
direction
display is limited.
Warning Indicators (see figure
The function of the warning indicators is also op-
erative in stand-by mode.
The battery is almost empty:
Recharge the battery.
The motor is starting to overheat:
Switch the machine off and allow to cool
down. Alternatively, run the machine at full
speed without load until the warning indicator
goes out.
Adjustment Aid
The display is for guidance. The settings are to
be checked by carrying out a practical test.
Material Selection (see figure
Select the material to be worked by (multiple)
pressing of the left push-button key:
Steel
Softwood
Hardwood
Shown in the example: Hardwood.
Application Selection (see figure
Select the application by (multiple) pressing of
the right push-button key:
+ Driving in screws (4 Diameter ranges)
+ Drilling holes (2 Diameter ranges)
Recommendation (see figure
The indication gives a recommendation for the
optimum setting of your cordless screwdriver. Ad-
just the proposed values on your cordless screw-
driver.
1st gear/2nd gear
Torque range (Level 1 – 5, 5 – 15,
15 – 25, "Drilling")
Shown in the example: 2nd gear; Torque
range 5 – 15.
English - 3
)
E
F )
G )
H )