Speakers; Remove The Battery; Remove The Optical Drive; Remove The Top Cover From The Base Enclosure - HP 17-P series Maintenance And Service Manual

5. Lift the system board (2), and then remove the system board (3) by sliding it up and to the right at
an angle.
Reverse this procedure to install the system board.

Speakers

Description
Speaker Kit (includes left and right front speakers and cables)
Before removing the speakers, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive (see
6. Remove the top cover from the base enclosure (see
7. Remove the WLAN module (see
8. Remove the system board (see
Battery on page 26),
Optical drive on page
WLAN module on page
System board on page
27).
Base enclosure on page
42).
50).
Component replacement procedures
Spare part number
763717-001
30).
53