Peavey tour tko combo Operating Manual page 23

TNT Rear Panel
17
18
AC POWER INLET:
18
This is the receptacle for an IEC line cord, which provides AC power to the unit. Connect the line cord to this
connector to provide power to the unit. Damage to the equipment may result if improper line voltage is used.
(See line voltage marking on unit).
Never break off the ground pin on any equipment. It is provided for your safety. If the outlet used does not
have a ground pin, a suitable grounding adapter should be used, and the third wire should be grounded
properly. To prevent the risk of shock or fire hazard, always make sure that the amplifier and all associated
equipment is properly grounded.
NOTE: FOR UK ONLY
As the colors of the wires in the mains lead of this apparatus may not correspond with the colored markings
identifying the terminals in your plug, proceed as follows: (1) The wire that is colored green and yellow must
be connected to the terminal that is marked by the letter E, or by the Earth symbol, or colored green or green
and yellow. (2) The wire that is colored blue must be connected to the terminal that is marked with the letter
N, or the color black. (3) The wire that is colored brown must be connected to the terminal that is marked
with the letter L, or the color red.
TWEETER SWITCH
19
This switch turns the tweeter on/off. Usually when the CRUNCH effect is engaged, this switch would be
switched to the OFF position.
EXTERNAL SPEAKER OUTPUT
20
"Combi" type powered output for powering a passive enclosure.
FOOTSWITCH JACK
21
Plug your TNT footswitch into this 1/4" jack. The footswitch controls the crunch effect and the compressor
on/off.
NOTE:
The crunch and compressor buttons MUST be pushed in to operate with the footswitch.
EFFECTS LOOP
22
The Send Jack provides a pre amp output that may be used to drive slave amplifiers and external effects
processors. The Return Jack provides a power amp input for the last effect in the chain.
NOTE: When using the unit as a slave power amplifier, the Return Jack should be used as the input.
GROUND LIFT
23
This button is provided to prevent a ground loop that may result in "hum" noise. When depressed (IN
position), Ground Lift is engaged.
DIRECT INTERFACE (DI)
24
This is a built-in, balanced Direct Interface used to send a buffered, unprocessed signal to an external mixer.
PEAVEY LOGO BACKLIGHT SWITCH
25
This button turns the backlight on the Peavey Logo on or off.
19 20 21 22 23 24 25