Sanyo SAP–K301AH Technical & Service Manual page 67

Anti-Mold Filter
How to remove the
anti-mold filter
Cleaning
How to replace the
anti-mold filter
OI-400-23EG
Care and Cleaning (continued)
The anti-mold filter behind the air intake grille should be checked and
cleaned at least once every two weeks.
1. Grasp both ends of
the air intake grille
and pull it out and
up.
2. Push the anti-mold
filter up slightly,
and then pull
it down.
Use a vacuum cleaner to remove light dust. If there is sticky dust on the
filter, wash the filter in lukewarm, soapy water, rinse it in clean water,
and dry it.
1. With the ''FRONT''
mark facing you, slide
the anti-mold filter up
into the unit and then
lower the handle into
the groove on the
unit.
2. After installing the
anti-mold filter, press
the locations marked
by the arrows ( )
and close the air
intake grille.
Air intake grille
Anti-mold filter
Air intake grille
Anti-mold
filter
Insert into the groove on the unit.
23