Sanyo SAP–K301AH Technical & Service Manual page 53

TIMER ON button
TIMER OFF button
TIMER SET button
MODE selector button
(AUTO)
(COOL)
FLAP button
NOTE
FAN SPEED selector
1 HR. TIMER button
(1-HOUR OFF TIMER)
ACL button
(ALL CLEAR)
ADDRESS switch
SENSOR button
NOTE
Automatic switching between cooling and heating
•
This unit automatically switches between cooling operation and heating operation according to the
difference between the room temperature and the temperature setting.
The remote control unit sends the temperature signal to the air conditioner regularly at three
NOTE
minute intervals. If the signal from the remote control unit stops for more than ten minutes due
to the loss of the remote control unit or other trouble, the air conditioner will switch to the
temperature sensor which is built into the indoor unit and control the room temperature. In
these cases, the temperature around the remote control unit may differ from the temperature
detected at the air conditioner's position.
OI-400-09EG
Remote Control Unit (continued)
: The air conditioner starts at the set time.
: The air conditioner stops at the set time.
This button is used to set the time at which you wish the air
conditioner to go on or off.
Use this button to select AUTO, HEAT, DRY or COOL mode.
: When this setting is selected, the air conditioner calculates
the difference between the thermostat setting and the room
temperature and automatically switches to the ''COOL'' or
''HEAT'' mode as appropriate.
(HEAT) : The air conditioner makes the room warmer.
(DRY) : The air conditioner reduces the humidity in the room.
: The air conditioner makes the room cooler.
Press this button either to select to set the airflow direction to one of
the six possible positions manually, or to select the sweep function,
which moves the flap up and down automatically.
: The airflow direction can be set manually. (six positions)
: The flap moves up and down automatically.
To switch to the sweep function (
hold down the FLAP button.
: The air conditioner automatically decides the fan speeds.
button : High fan speed
: Medium fan speed
: Low fan speed
: When you press this button, regardless of whether the unit is
1
HR.
operating or stopping, the unit operates for one hour and
then shuts down.
Puts the remote control unit into pre-operation status. Always press
this button after replacing the batteries.
Change the address switch to prevent mixing of signals from
•
remote control units when two Sanyo air conditioners are installed
next to each other. Normally, the address switch is set to A. When
switching the address, the remote control must be changed, and the
jumper cables on the indoor unit board must be cut. For more
information, please contact the dealer where you made the
purchase.
Normally, the tabs on the remote control unit should not be bent.
•
When you press this button (use a small-tipped object such as a
ballpoint pen), the
temperature is detected by the sensor which is built into the indoor
unit and the air conditioner is controlled accordingly.
If the remote control is located near a heat source, such as a space
heater or in direct sunlight, press the SENSOR button to switch to
the sensor on the indoor unit.
) when in the manual ( ) mode,
mark will appear at the display. And the room
9