Table of Contents
Advertisement
Using Your Removable Handheld Steamer
with the Different Accessories - cont.
USING THE CONCENTRATOR NOZZLE
Cleaning Tip: The Concentrator Nozzle creates direct
steam spray to clean and sanitise hard to reach nooks
& crannies and other places where germs may build
up. Use the Concentrator Nozzle to loosen and dislodge
compact dirt often found in corner and tight places where
traditional methods and cleaning tools tend to push dirt
into, making it tough to reach and clean. Spray direct
steam and wipe clean with a wet cloth or paper towel.
1
Attach the Concentrator Nozzle by pressing the
nozzle onto the Accessory Hose until it clicks into
place. (fig. 11)
2
Press the power button to start the steamer.
For effective cleaning, hold the steam output nozzle
1-2 inches away from the surface you're cleaning.
CAUTION: Do not press the power button until
the Concentrator Nozzle is snapped into the
accessory hose of your Handheld Steamer.
3
To remove the Concentrator Nozzle, press and hold
the accessory release button, then pull it out of the
Accessory Hose.
CAUTION: Do not press the power button while
removing the Concentrator Nozzle. Avoid
touching the tip of the Concentrator Nozzle, as
this will be very hot after steaming.
NOTE: The Handheld Steamer may continue to emit
steam for a few seconds after the power button is
pressed to turn the unit off. This is normal, and the
steaming will eventually come to a stop.
11
11 3444-0175
fig. 11
USING THE FLAT SCRUBBER
Cleaning Tip: The Flat Scrubber is designed for cleaning
a variety of surfaces and is exceptional on those that
are large and flat including counter tops, table tops,
walls mirrors, windows, stairs, shelves and other similar
surfaces. Super absorbent microfibre bonnet loosens,
lifts, and locks in dirt and grime while sanitising at the
same time.
1
To attach the All-Purpose Scrubber Bonnet, place
the bonnet exterior side down on a flat surface
(lavender tab indicates the bottom of the bonnet) and
insert the top of the Flat Scrubber Tool into the top
portion of the bonnet and then pull the bonnet over
each side of the back edge.
2
Attach the Flat Scrubber Tool by snapping into the
Accessory Hose until it clicks into place. (fig. 12)
3
Press the power button to start steaming.
4
To remove the Flat Scrubber Tool, press and hold
down the Accessory release button. Then slide out
the Flat Scrubber Tool.
CAUTION: Turn the unit off before attaching or
removing the Flat Scrubber Tool.
CAUTION: Do not use the Flat Scrubber Tool
without the All-Purpose Scrubber Bonnet
attached.
fig. 12
Advertisement
Table of Contents
