Selecting A Location And Connecting Input Power - Miller MILLERMATIC DVI Owner's Manual

4-13. Selecting A Location And Connecting Input Power

18 in (457 mm) of
space for airflow
Y Do not move or operate unit
where it could tip.
Y Special installation may be required
where gasoline or volatile liquids
are present − see NEC Article 511 or
CEC Section 20.
For 115 volts ac input power, a 15 or 20
ampere individual branch circuit protected
by time-delay fuses or circuit breaker is
required. For 230 volts ac input power, see
Section 4-10.
1 Rating Label
Supply correct input power.
OM-1330 Page 16
Y Do Not cut off power cord connector and attempt to hard
wire the power cord. The power cord connector and plugs
are designed to work with pre-installed outlet receptacles.
11
1
2
2 Power Cord Connector
3 Plug − NEMA Type 5-15P
4 Receptacle − NEMA Type 5-15R
(Customer Supplied)
5 Plug − NEMA Type 5-20P (Optional)
6 Receptacle NEMA Type 5-20R
(Customer Supplied)
7 Plug − NEMA Type 6-50P
8 Receptacle − NEMA Type 6-50R
(Customer Supplied)
9 Plug − NEMA Type 10-50P (Optional)
3
5
7
9
10 Receptacle − NEMA Type 10-50R
(Customer Supplied)
Select plug for power supply receptacle
available at site. Install plug onto power
cord adapter. As threaded collar is
tightened, push plug onto adapter until
collar is completely tight.
Connect plug to receptacle.
11 Cylinder Support Bracket
Holes in the bracket provide a location to
store the unused power cord plugs.
4
6
8
10
803 862-C