Basic Settings; Video; General - Blaupunkt Philadelphia 835 Operating Instructions Manual

Basic settings

In the settings menu of the device, you can adjust the ba-
sic settings for the diff erent functions of the Philadelphia
835 to your requirements.
u Press the SETUP button
- or -
u In the main menu, press the Settings button.
The settings menu is displayed, the General sub-
menu is activated.
u Call up the submenus with the buttons in the lower
area of the settings menu.

Video

The following settings are possible:
Aspect ratio – Adjust image format
Video Input – Adjust the colour system of the external
video input
Rear view camera – Adjust back-up camera (if a back-up
camera is connected)
Parking – When "Parking" is activated, the display of the
Philadelphia 835 switches to parking mode when park-
ing.
Backcar mode – Select the parking aid (parking radar or
back-up camera) to be shown on the display.
Parking volume – Adjust the volume of the active audio
source while parking.
DivX registration code – Display of the DivX® registra-
tion code
7
.

General

The following settings are possible:
Radio region – Select the reception region for the radio
reception.
Background light off – If this value is set, the display of
the radio is completely switched off after 10 or 20 sec.
without use.
Dimmer mode – Adjust the display brightness
VarioColour – Adjust the illumination colour of the but-
tons.
Beep – Switch confi rmation beep on/off
Wallpaper – Select the wallpaper for menus. Various mo-
tifs can be selected in the device. You can also select your
own images which you previously stored on the MicroSD
card.
Calibration – The touchscreen can be calibrated here.
SWC – The buttons of a connected steering wheel con-
trol can be confi gured here.
Theft protection – Activate/deactivate the code query.
If the code query is activated, the four-digit code num-
ber must be re-entered every time the device is discon-
nected from the vehicle system voltage (e.g. removal of
the battery for repairs).
Security code – You can change the code number. To
change the code number, enter the four-digit code num-
ber. The code number is set to 0000 at the factory.
Load factory – Resets all personalised settings. With the
exception of the personally selected security code.
Basic settings
43