Maintenance - Shark NV360 Series Owner's Manual

Maintenance

COMPONENT
1 Dust Cup
2 Pre-Motor Foam Filter
3
Pre-Motor Felt Filter
4
Post-Motor HEPA Filter
Fig. 22
EMPTYING THE DUST CUP
The dust cup needs to be emptied each time you vacuum
and periodically during cleaning, when the dust cup
appears full.
1
Undo the latches on the sides of the dust cup by
lifting them up and outwards to remove the dust cup
from the motor base. (Fig. 22)
2
Hold the dust cup over a trash receptacle and
press the bottom door release button. (Fig. 23)
Tap gently to empty contents. Press the door shut
again until it clicks.
3
If needed, turn the dust cup upside down over the
trash receptacle and press the top door release
button. (Fig. 24) Tap gently to remove contents.
Use a dry cloth or paper towel to remove debris
stuck to the screen filter inside the dust cup. Press
the door shut again until it clicks.
4
Replace the dust cup on top of the motor base. Hook
the two latches onto the tabs on the sides of the
dust cup and push down to lock.
17 1-800-798-7398
MAINTENANCE SCHEDULE
Empty each time you vacuum.
Rinse and air dry every 3 months under normal use.
Rinse and air dry every 3 months under normal use.
Clean once every 2 years or as needed.
Fig. 23
Screen
Filter
Fig. 24
IMPORTANT: Loss of Suction may
occur if foam filters are not cleaned
every 3 months. Rinse and allow to
air dry completely. Foam filters may
appear dirty after use - this is normal.
Fig. 25
CLEANING THE PRE-MOTOR FILTERS
1
Remove the dust cup.
2
Pull the 2 filters out from the top of the motor base.
(Fig. 25)
3
Rinse the filters thoroughly in lukewarm water until
the water runs clear.
DO NOT put the filter in the washing machine or
dishwasher.
NOTE: The material in the filter will discolor over
time. This is NORMAL and will not affect the
performance of the filter.
4
Squeeze out excess water and let air-dry for at least
24 hours before replacing. Do not use a hair dryer or
other heating methods to dry.
5
Place the felt filter in first, then the foam filter.
6
Replace the dust cup.
Pre-Motor
Foam Filter
Felt Filter
Post Motor
HEPA Filter