Directions For Use; Optional Accessories; Dry-Ironing; Steam Rotary Nozzle - Kärcher VAPORAPID 1501 Manual

K 1501
·

Dry-ironing

– If you wish to iron without using steam, switch
the steam supply switch (15) on the main unit
to ON, and the heater switch (14) to OFF.
– Set the temperature control according to the
type of fabric that you are going to iron. The
symbols on the control have the following
meanings:
Synthetic fibres:
Wool:
Linen:
14

2. Directions for use

•
• •
• • •

2.8 Optional accessories

·
Only accessories approved by the manufacturer
may be used with this unit.
Wallpaper remover (Order no. 2.863-062)
·
With the wallpaper
remover you can use the
steam cleaner for
stripping wallpaper.
·
Procedure:
– Place the wallpaper
remover with its entire surface on the edge of
a sheet of wallpaper. Allow the steam to
penetrate until the wallpaper is soaked through
(approx. 10 sec.).
– Without switching it off, move the wallpaper
remover to a new location. Use a putty knife to
lift the loosened wallpaper, and pull it off
completely.
– The steam may not be able to readily penetrate
woodchip wallpaper that has been painted
several times. In this case we recommend that
you go over the wallpaper with a spiked roller
before steam is applied.
Steam Rotary Nozzle (Order no. 2.863-094)
·
The rotary nozzle can be attached
directly or with the extension tubes
(12) to the steam handgun (1), as
required.
·
Use the rotary nozzle for loosening
stubborn dirt over large areas.
Cloth set (Order no. 6.960-019)
– 3 terry-towelling slip-overs, 2 large wiping cloths.
Circular brush set (Order no. 2.863-058)
– 4 circular brush attachments for spot nozzle.
Biological decalcifying liquid RM 511
(Order no. 6.290-239)
– 3 x 100 g powder for descaling the boiler.
– For instructions for use, see Ch. 3: "Care,
Maintenance & Troubleshooting".