Philips S91 series Manual page 24

24
English
SmartClean system Plus only:
the drying phase starts automatically. During
this phase, the drying symbol flashes. When the
drying phase is done (after approx. 4 hours), the
drying symbol lights up continuously.
When the cleaning program is done, the ready
symbol lights up continuously.
30 minutes after the cleaning program and
charging have been completed, the SmartClean
system switches off automatically.
The battery symbol lights up continuously to
indicate that the shaver is fully charged.
Charging takes approx. 1 hour.
5 SmartClean system Basic only: To let the
shaver dry, you can leave it in the SmartClean
system until your next shave. You can also
remove the shaver from the SmartClean system,
shake off excess water, open the shaving unit
and let the shaver air dry.
Note: If you press the on/off button of the
SmartClean system during the cleaning program,
the program aborts. In this case, the rinsing or
drying symbol goes out.
Note: If you remove the supply unit from the wall
socket during the cleaning program, the program
aborts.
Replacing the cartridge of the SmartClean
system
Replace the cleaning cartridge when the
replacement symbol flashes orange or when you
are no longer satisfied with the cleaning result. If
you clean the shaver in the SmartClean system
once a week, the SmartClean cartridge lasts
approximately three months.
After the rinsing phase,