Installing a DC power module and connecting
the power cord
Installing a DC power module
Follow these steps to install a DC power module:
1.
Wear an ESD-preventive wrist strap, and make sure that the wrist
strap makes good skin contact and is properly grounded.
2.
Use the Phillips screwdriver to loosen the captive screws on the
blank panel, and remove the blank panel from the slot to be used,
as shown in
3.
Unpack the DC power module, and mark the positive terminal and
negative terminal of the power module according to the marks on
the power module panel.
4.
Use the Philips screwdriver to loosen the captive screws at the right
side of the power source connector, remove the power source
connector from the power module, and keep it for future use.
Figure 7 Remove the power source connector from the power module
Figure 4
13