Sony RDR-GXD455 Operating Instructions Manual page 60

IJvJ
.~
l!(E]1-----00:00:07.
~.se
i]
Title No.01
8
End 00:00:00 Finish
o
Mayl02/2007 08:00 PM
1
Press TITLE LIST.
When editing a DVD-RW (VR mode) or
DVD-R (VR mode), press ORIGINAL/
PLAYLIST to switch to the "Title List
(Original)," if necessary.
2
Select a title, and press ENTER.
The sub-menu appears.
3
Select "A-B Erase," and press ENTER.
The display for setting point A and B appears.
"Start" is selected.
4
Press ENTER at the start point of the
section to be erased (point A).
You can use
[:::>
PLAY,
~
....... / ...
~,
....
/~,.
STOP, and II PAUSE to find
the point. "End" is selected.
~ ~E
~00:00:10.s
..
rtOOOOlO
~
i]
Title No.01 End 00:00:00
~
o
May/02/2007 08:00 PM
~
O.
A-BErase
O.
A-BErase
Title NO.01
Title No.01
10:10AM
10:10AM
.~*
Hints
• A chapter mark is inserted after the scene was erased.
The chapter mark divides the title into separate chapters
on either side of the mark.
• You can also erase a section of a Playlist title (page 64).
• Images or sound may be momentarily interrupted at the
point where you erase a section of a title.
• Sections shorter than five seconds may not be erased.
• The start and end points of a title may be different from
what you have set.
• The total playing time of the title does not change even
if a scene was erased.
• If you erase an original title used in a Playlist, that
Playlist is also erased.
Dividing a title into two (Divide Title)
Im!lJIIIi.E laD
You can divide a title into two. Note that dividing
original titles cannot be undone.
1
Press TITLE LIST.
When editing a DVD-RW (VR mode) or
DVD-R (VR mode), press ORIGINAL/
PLAYLIST to switch to the "Title List
(Original)," if necessary.
2
Select a title, and press ENTER.
The sub-menu appears.
3
Select "Divide Title," and press ENTER.
The display for setting the dividing point
appears.
"Point" is selected.
Title NO.01
~ .~
!![EI 0 0 : 0 0 : 0 7 .
i]
Title No. 01
o
May/02/2007 08:00 PM End 00:00:00
60
5
Press ENTER at the end point of the section
(point B).
"Erase" is selected.
To reset the start or end point, select "Start" or
"End" and repeat from step 4 or 5.
6
Press ENTER.
The display asks for confirmation.
7
Select "OK," and press ENTER.
The scene is erased.
To continue, repeat from step 4.
To finish, select "Finish," and press ENTER.
O.
Divide Title (Original) 10:10AM