Metabo BS Li Partner Edition Original Instructions Manual page 11

17026947_0209 BS 18 Li BS 14_4 Li BS Li Partner Edition.book Seite 11 Dienstag, 17. Februar 2009 10:33 10
7.5 Selecting gear stage
Do not set the switch (3) unless the motor
has stopped completely!
Actuate the switch (3).
1st gear setting (low speed), very high torque
2nd gear setting (high speed)
7.6 Setting the torque limit
Turn the sleeve (2).
1... = Torque setting (for working with torque
control)
= Drill setting - no torque control (for
max. torque)
7.7 On/Off switch, setting the speed
Switching on, speed: press the trigger (10). Press
in the trigger to increase the rotational speed.
Switching off: Release the trigger (10). Note: The
noise that the machine makes when it
switches off is due to the design (quick stop)
and has no influence on the function or the
service life of the machine.
7.8 LED lights
For working on dimly lit areas. The LED lights (9)
light up when the machine is switched on.
7.9 Keyless chuck
1
GRIP, ZU
Opening the chuck
Turn sleeve (1) in the direction "AUF,
RELEASE".
Clamping the tool
- Open the keyless chuck and insert the tool as far
as possible.
- Turn the sleeve (1) in the direction of "GRIP, ZU"
until the tool is clamped securely.
- With a soft tool shank, retightening may be
required after a short period of operation.
AUF, RELEASE
Unscrewing the chuck
a b 1
- Open the keyless chuck.
- Slacken the screw (a) (note: left-handed thread!).
- Unscrew the keyless chuck (1) using a spanner
(b).
Employ the same procedure when attaching the
chuck, except in reverse order.
Cleaning
From time to time, hold the machine vertically with
the chuck facing downwards and turn the sleeve
fully in the direction "GRIP, ZU" and then turn fully
in the direction "AUF, RELEASE". The dust
collected falls from the keyless chuck.
8 Tips and Tricks
Drilling
- Preferably in 2nd gear (high speed).
- In the case of deep bores, pull the drill bit out of
the bore from time to time in order to remove the
drill dust or swarf.
Screws
- Preferably in 1st gear (low speed) and with
torque control.
Thread tapping
- Lubricate the dies.
- Select 1st gear (low speed).
- Adjust torque control.
9 Accessories
Use only genuine Metabo accessories.
If you need any accessories, check with your
dealer.
For dealers to select the correct accessory, they
need to know the exact model designation of your
power tool.
See page 4.
A Chargers
B Battery packs with different capacities.
Use battery packs only with voltage suitable
for your power tool.
For a complete range of accessories, see
www.metabo.com or the main catalogue.
ENGLISH
ENG
11