Table of Contents
Advertisement
Hardware Preparation and Installation
2
N
ote
On the MVME197DP/SP module series there is a bank of ten two-way switch
segments which is designated connector J4. This connector switch is not used
and all ten switch segments are soldered over.
Refer to the SIMVME197 Support Information User's Manual for detailed
connector signal descriptions.
Installation Instructions
The following sections discuss installation of the MVME197DP/SP into a VME
chassis, and system considerations. Ensure that the BOOT ROM device is
installed. Ensure that all switches are configured as desired.
MVME197 Module Installation
Now that the MVME197DP or MVME197SP module is ready for installation,
proceed as follows:
a. Turn all equipment power OFF and disconnect the power cable from the
power source.
C
aution
!
WARNING
b. Remove the chassis cover as instructed in the equipment user's manual.
c. Remove the filler panel(s) from the appropriate card slot(s) at the front and
rear of the chassis (if the chassis has a rear card cage). The MVME197
module requires power from both P1 and P2. It may be installed in any
double-height unused card slot, if it is not configured as the system
controller. If the MVME197 is configured as the system controller, it must
2-6
The MVME197LE module series and the MVME197DP/SP
module series are different artworks. On the MVME197LE
series, the mezzanine connector is designated J2, while on
the MVME197DP/SP series, the same mezzanine connector
is designated J1. The basic form, fit, and function of this
mezzanine connector is not changed.
Inserting or removing modules while power is applied
could result in damage to module components.
DANGEROUS VOLTAGES, CAPABLE OF CAUSING
DEATH, ARE PRESENT IN THIS EQUIPMENT. USE
EXTREME CAUTION WHEN HANDLING, TESTING,
AND ADJUSTING.
User's Manual
Advertisement
Table of Contents
