Turning On/Off The Power; Initial Setup; Watching Tv - Sharp Aquos LC-32D44U Operation Manual

Watching TV

Turning On/Off the Power

Initial Setup

When you turn on the TV for the fi rst time, it will
automatically memorize the broadcasting channels
available in the region where you live. Perform the
following steps before you press POWER on the
remote control unit.
1. Insert the batteries into the remote control unit. (See page 8.)
2. Connect the antenna cable to the TV. (See page 8.)
3. Plug in the AC cord to the AC outlet. (See page 7.)
Language (Language setting)
Select from among 3 languages: English, French and Spanish.
1 Press a/b to select the desired language listed on the
screen, and then press ENTER.
Language
TV Location
Air/Cable
CH Search
TV Location
Select "Home" or "Store" for the location where you plan to
install the TV.
2 Press c/d to select "Home" or "Store".
Press ENTER to enter the setting.
Example
Language
TV Location
Air/Cable
CH Search
• If you select "Home", AV MODE is set to "STANDARD".
• If you select "Store", AV MODE is set to "DYNAMIC (Fixed)".
In case no remote control signal is received within 30 minutes,
AV MODE will change to "DYNAMIC(Fixed)" automatically.
• For changing the TV Location after the setting, see "EZ
Setup" on page 20.
Press POWER on the TV or on the remote control unit to turn the
power on.
• POWER indicator (Green): The TV is on. (After a few seconds, a window
appears with sound.)
POWER
• The initial setup starts when the TV powers on for the fi rst time. If the TV has
been turned on before, the EZ Setup will not be invoked. See page 20 for
performing EZ Setup from the Setup menu.
Press POWER on the TV or on the remote control unit again to turn the
POWER
power off.
(On/Standby)
• The TV enters standby and the image on the screen disappears.
• The POWER indicator on the TV turns off.
• If you are not going to use this TV for a long period of time, be sure to remove
the AC cord from the AC outlet.
• Weak electric power is still consumed even when the TV is turned off.
English
Français
Español
Home Store
Air/Cable (Antenna setting)
Make sure what kind of connection is made with your TV
when selecting "Air" or "Cable".
Press c/d to select "Air" or "Cable".
3
Press ENTER to enter the setting.
Language
TV Location
Air/Cable
CH Search
CH Search (Channel search)
Channel auto search makes the TV look for all channels
viewable in the set area.
4
When "Air" is selected in Antenna setting:
Press c/d to select "Start", and then press ENTER.
Language
TV Location
Air/Cable
CH Search
When "Cable" is selected in Antenna setting:
Press a/b to select "Analog & Digital Search Start" to
search both analog and digital broadcasts, or to select
"Analog Search Start" to search only analog broadcasts,
and then press ENTER.
Language
TV Location
Air/Cable
CH Search
• The Channel search will start automatically.
• To exit the Channel search screen, select "Cancel", and
then press ENTER.
• If no channel is found, confi rm the type of connection made
with your TV and try EZ Setup again.
(See page 20.)
12
Example
Air Cable
Start Cancel
Analog & Digital Search Start
Analog Search Start
Cancel