Table of Contents
Advertisement
7.
Never touch any moving parts, including the blade, while the saw is in use.
8.
Never remove any safety devices or blade guards; use of the tool without them would
be hazardous.
9.
Never lock the safety cover; always confirm that it slides smoothly before using the
tool.
10. Never damage the power cord of the tool.
11. Never attempt to move a plugged-in POWER TOOL while your finger is on the starting
switch.
12. Never use the POWER TOOL if the starting switch does not turn on and off properly.
13. Never use the POWER TOOL if the plastic housing or the handle is cracked or deformed.
14. Never use the POWER TOOL near flammable liquids or gases because sparking can
cause an explosion.
15. Never clean plastic components with solvents because the plastic may dissolve.
16. Never operate the saw unless all the blade guards are in place.
17. Never raise the saw blade from the workpiece until it has first come to a complete stop.
18. When slide cutting, never pull the handle toward the operator, since this could cause
the saw blade to kick up from the workpiece. Always push the handle away from the
operator in a single, smooth motion.
19. Never place your limbs inside of the line while the tool is being operated. This may
cause hazardous conditions.
20. Never use abrasive type blades on this saw.
21. Never expose to rain or use in damp locations.
WARNING
FOR YOUR OWN SAFETY READ THIS HANDLING INSTRUCTIONS
BEFORE OPERATING THE SLIDE COMPOUND MITER SAW
1.
Always wear eye protection when using the slide compound miter saw.
2.
Always keep hands out of the path of the saw blade.
3.
Never operate the saw without the guards in place.
4.
Never perform any freehand operation with the slide compound miter saw.
5.
Never reach around the saw blade.
6.
Always turn off tool and wait for saw blade to stop before moving workpiece or changing
settings.
7.
Always disconnect power before changing blade or servicing.
8.
Saw blade diameter is 216mm (8-1/2").
9.
No load speed is 4900/min.
REPLACEMENT PARTS
When servicing use only identical replacement parts.
Repairs should be conducted only by a Hitachi authorized service center.
6
Advertisement
Table of Contents
