Preparation Before Operation - Hitachi C 8FSC Handling Instructions Manual

PREPARATION BEFORE OPERATION

Make the following preparations before operating the power tool:
1. Installation
150mm (5-29/32")
9mm (11/32")
3 Holes
300mm (11-13/16")
Attach the power tool to a level, horizontal work bench in accordance with Fig. 4.
Select 8mm (5/16") diameter bolts suitable in length for the thickness of the work bench.
Bolt length should be at least 25mm (1") plus the thickness of the work bench.
For example, use 50mm (2") or larger bolts for a 25mm (1") thick work bench.
The holder attached to the rear of the base helps stabilize the power tool.
Holder
Adjust the base
holder until its
bottom surface
contacts the work
bench surface.
6mm bolt
Move
Fig. 5
Base
Work bench
Fig. 4
Base holder adjustment:
Loosen the 6mm bolt with the supplied 10mm
box wrench.
Adjust the base holder until its bottom surface
contacts the work bench surface.
After adjustment, firmly tighten the 6mm bolt.
8mm (5/16") bolt
8mm (5/16") nut
11