Exmark VANTAGE X Series Operator's Manual page 50

Troubleshooting
Problem
Blades do not rotate.
Clutch will not engage.
Possible Cause
1. Drive belt is off pulley.
2. Deck belt is worn, loose or broken.
3. Deck belt is off pulley.
4. Broken or missing idler spring.
5. Damaged electric clutch.
6. OPC levers are released.
1. Fuse is blown.
2. Low voltage supply at the clutch.
3. Damaged coil.
4. Inadequate current supply.
5. Rotor/armature airgap is too large.
6. OPC levers are released.
50
Corrective Action
1. Check belt for damage; replace if
necessary. Install drive belt and check
adjusting shafts and belt guides for correct
position.
2. Install new deck belt.
3. Install deck pulley and check the idler
pulley, idler arm and spring for correct
position and function.
4. Replace the spring.
5. Contact an Authorized Service Dealer.
6. Depress OPC levers.
1. Replace fuse. Check coil resistance,
battery charge, charging system, and
wiring connections and replace if
necessary.
2. Check coil resistance, battery charge,
charging system, and wiring connections
and replace if necessary.
3. Replace clutch.
4. Repair or replace clutch lead wire or
electrical system. Clean connector
contacts.
5. Remove shim or replace clutch.
6. Depress OPC levers.