Remote Control Car Starter Installation Manual for Models 28624, 28628
DesignTech International, Inc. • 7955 Cameron Brown Court • Springfield, Virginia 22153 USA • www.designtech-intl.com • 703-866-2000 or 800-337-4468
Congratulations on your purchase of the AutoCommand
by remote control from the comfort of your home or office in order to cool it down in the summer or heat it up in the winter.
AutoCommand
®
OEM Series is for automatic transmission/fuel injected vehicles only. It is an extremely sophisticated system with multiple built-in safety and security
features.
• Will start your car by remote control, and run the heater, defroster, or
air conditioner to warm up or cool down the car.
• Is designed to start the car if it is in park, and only if the hood is
closed.
• Has Lock, Unlock and Trunk keyless entry features.
• Will attempt to start the car for up to six seconds, but no longer (to
avoid damage to the starter motor). Should the car not start, or if it
stalls after starting, the remote starter will make two further attempts
to start it.
• Has alarm functions including starter kill which becomes active when
the doors are locked with the remote control.
• Will not let the car be driven without the key in the ignition.
• Shuts itself off automatically after 10 or 15 minutes (programmable) if
you forget to come out to your car.
Tools required to install the AutoCommand
Wire Cutters/Strippers
Soldering Iron
Pliers
Test meter
We highly recommend that all connections be soldered for reliability.
Parts List included with the AutoCommand
Remote Starter
Receiver Module
Antenna
Control Harness
(10 position)
2 Relays with relay harnesses
(Model 28628 only)
Following parts included in plastic baggy
Alcohol Pad
Alchohol
Pad
Green 30 A Fuse
On/Off Control Switch
Plug-In LED
3 Pin Door Harness
2 Protected by
DesignTech Labels
PLEASE READ COMPLETELY BEFORE BEGINNING
®
OEM Series Remote Car Starter. The AutoCommand
AutoCommand
®
OEM Series Car Starter:
®
OEM Series Unit:
Electrical Tape
Screwdriver
Drill with1/4"and 5/16"
drill bits
®
OEM Series Unit:
Transmitter
Siren (Model 28628 only)
6 Power and Ignition wires
Shock Sensor
(Model 28628 only)
Ring Terminal
2 Antenna Clips
Hood Pin Switch Set
2 Cable Ties
Yellow Butt Connector
Warning Label
OEM S
ERIES
®
OEM Series Remote Car Starter system allows you to start the car
• Will shut off if the brake pedal is pushed, the hood is opened, or the
transmission is shifted out of park - unless the key is in the ignition and
in the "run" position.
• Allows you to remove the key while leaving the car running with the
doors locked for up to 10 or 15 minutes utilizing the Quick Stop™ Op-
tion. (See Separate User Tip Sheet)
• Starts the car automatically whenever the temperature drops below
0
°
F (-18
°
C), or if the battery voltage drops below 11 volts when the
Cold Start™ Option is used. (See Separate User Tip Sheet)
• Has the "Daily Start™" feature which allows the vehicle to be started
at the same time the following day. (See Separate User Tip Sheet)
• Is quality engineered, microprocessor controlled, and made in the USA
to provide many years of reliable use.
• Comes with a lifetime warranty.
Wiring Diagram
Power Harness
Color
Pink
White
Yellow
Blue
Green
Black
Green "In-Gear" Loop
ON/OFF Switch Jack
LED Light Jack
Lock/Unlock/Trunk Harness
4-Pin Shock Sensor Input
Color
1. Yellow
2. Blue
3. Brown
4. Brown/White
5. White/Black
6. Orange
7. Purple
8. Green
9. Red/White
10. Red/Black
*For free vehicle-specific wire information consult our website at
www.designtech-intl.com
Function
Circuit Type
Required
Power (+12V)
Input
Yes
Accessory
Relay Output
Yes
Starter
Relay Output
Yes
Ignition 1
Relay Output
Yes
Ignition 2
Relay Output
Consult Wiring Diagram
Ground
Input
Yes
LED Light
White – Option
Red – Code Learn
Coax Antenna Jack
Control Harness
Function
Circuit Type
Required
Lights
Relay Output
No
Horn
(–) 400 mA
No
Accessory
(–) 400 mA
No
Alarm Disable
(–) 400 mA
Consult Wiring Guide
Ignition 3
(–) 400 mA
Consult Wiring Guide
Brake
(+) Input
Yes
Hood
(–) Input
Yes
Tach
(–) Input
No
Alarm Input
(–) Input
No
Diesel
(+/–) Input
No
v1.1 J2428