Remote Control Car Starter Installation Manual for Models 25524, 25528
DesignTech International, Inc. • 7955 Cameron Brown Court • Springfield, Virginia 22153 USA • www.designtech-intl.com • 703-866-2000 or 800-337-4468
Congratulations on your purchase of the AutoCommand
to start the car by remote control from the comfort of your home or office in order to cool it down in the summer or heat it up in the winter.
AutoCommand
®
Professional Series is for automatic transmission/fuel injected vehicles only. It is an extremely sophisticated system with multiple built-in safety and
security features.
• Will start your car by remote control, and run the heater, defroster, or
air conditioner to warm up or cool down the car from up to 1,000 feet
away.
• Is designed to start the car only if it is in park, and only if the hood is
closed.
• Has Lock, Unlock and Trunk keyless entry features.
• Will attempt to start the car for up to six seconds, but no longer (to
avoid damage to the starter motor). Should the car not start, or if it
stalls after starting, the remote starter will make two further attempts
to start it.
• Has alarm functions including starter kill which becomes active when
the doors are locked with the remote control.
• Will not let the car be driven without the key in the ignition.
• Shuts itself off automatically after 10 or 15 minutes (programmable) if
you forget to come out to your car.
Tools required to install the AutoCommand
Wire Cutters/Strippers
Soldering Iron
Pliers
Test meter
We highly recommend that all connections be soldered for reliability.
Parts List included with the AutoCommand
Remote Starter
Receiver Module
Antenna
Control Harness
(10 position)
2 Relays with relay harnesses
(Model 25528 only)
Following parts included in plastic baggy
Alcohol Pad
Alchohol
Pad
Green 30 A Fuse
On/Off Control Switch
3 Pin Door Harness
2 Protected by
DesignTech Labels
P
PLEASE READ COMPLETELY BEFORE BEGINNING
®
Professional Series Remote Car Starter. The AutoCommand
AutoCommand
®
Professional Series Car Starter:
®
Professional Unit:
Electrical Tape
Screwdriver
Drill with1/4"and 5/16"
drill bits
®
Professional Unit:
Transmitter
Siren (Model 25528 only)
6 Power and Ignition wires
Shock Sensor
(Model 25528 only)
Ring Terminal
Hood Pin Switch Set
2 Cable Ties
Plug-In LED
Yellow Butt Connector
Warning Label
R O F E S S I O N A L
®
Professional Series Remote Car Starter system allows you
• Will shut off if the brake pedal is pushed, the hood is opened, or the
transmission is shifted out of park - unless the key is in the ignition and
in the "run" position.
• Allows you to remove the key while leaving the car running with the
doors locked for up to 10 or 15 minutes by utilizing the Quick Stop™
Option. (See Separate User Tip Sheet.)
• Starts the car automatically whenever the temperature drops below
0
°
F (-18
°
C), or if the battery voltage drops below 11 volts when the
Cold Start™ Option is used. (See Separate User Tip Sheet.)
• Has the "Daily Start™" feature which allows the vehicle to be started
at the same time the following day. (See Separate User Tip Sheet)
• Is quality engineered, microprocessor controlled, and made in the USA
to provide many years of reliable use.
• Comes with a Limited Lifetime Warranty.
Wiring Diagram
Power Harness
Color
Pink
White
Yellow
Blue
Green
Black
GREEN In Gear Loop
ON/OFF Switch Jack
Control Harness
Color
Function
Circuit Type
Required
White/Black
Ignition #3
(–) 400 mA
Consult Wiring Guide*
Brown/White
Alarm Disarm (–) 400 mA
Consult Wiring Guide*
Brown
Accessory
(–) 400 mA
No
Blue
Horn
(–) 400 mA
No
Yellow
Lights
(+) Relay Output No
White - Option
Red LED Light
Red - Code Learn
Alarm Shock Sensor
Color
Function
Circuit Type
Required
Orange
Brake
(+) Input
Yes
Purple
Hood Switch
(-) Input
Yes
Green
Tach
(-) Input
No
Red/White
Alarm Input
(-) Input
No
Red/Black
Diesel
(+/-) Input
No
*For free vehicle-specific wire information consult our website at
www.designtech-intl.com
S
ERIES
Circuit
Function
Type
Required
Power (+12V)
Input
Yes
Accessory
Relay output
Yes
Starter
Relay output
Yes
Ignition 1
Relay output
Yes
Ignition 2
Relay output
Consult Wiring Guide*
Ground
Input
Yes
3 Pin
Lock/Unlock/Trunk
Coax
Antenna
Jack
v3.1 S25524/28