Hitachi FP-Z31 Operation Manual page 26

:-:-:-.·.
(3) The following messages are displayed when the centering has been set properly:
r
AUTO CENT··-/
Message displayed until set­
tins is completed.
(4) Examples of messages indicating improper setting:
This blinks
This blinks
LOW LIGHT ;}!;
:�.: INCREASE LIGHT LEV.
TAY AGAIN
This blinks
This blinks
::�_ � :·
H-CENT: OK
V-CENT: NG
TAY AGAIN
This blinks This blinks
AUTO CENT : ;-��::
: : : ; OBJECT?
_
TAY AGAIN
When the setting has not been made properly, change the object and set the AUTO CENT/AUTO SETUP
@
switch to the AUTO CENT position again.
6.3.7 Auto setup setting
- BAR/CAM switch (Vat "CAM":
· When the AUTO CENT/AUTO SETUP switch
level, auto black balance and auto white balance are all set in sequence
Shoot the object conforming to the conditions under which the white balance is set in section 6.3.4, and set
the AUTO CENT/AUTO SETUP switch
.... ... . . ...
:.:··· .
Th is blinks
o When there is insufficient I ight
o When the object has deep red or blue colors
o When the object does not have vertical contours
o When the object has deep colors
o When the object's level is sufficient but the object has no
contours
@
is set to the AUTO SETUP position. the auto black
@
to the AUTO SETUP position.
,
AUTO CENT: COMPLETED
H-CENT: OK
V-CENT: OK
Message with proper setting
\ L
..
/.
;, � .·J
(1) The
(2) Ex
I
BAR/C
When·
setting
the R/
compl€
(3) Di
·,;