Requiring only a single Power over Ethernet (PoE) cable drop to support voice, video, and data, the
MSM317 simplifies installation and decreases expensive site surveys required with traditional APs. Its
four-port switch and AP are centrally managed through the HP MSM7xx Controller. This means faster
configuration of multiple devices, automated software updates, and the delivery of a consistent set of
services throughout the network. In short, the MSM317 revolutionizes the deployment of converged
environments, all at a reduced cost of ownership.
Note:
This guide assumes the use of version 5.5 software on the MSM317 and
MSM7xx Controller. If you are using an older version, it is recommended
that you upgrade immediately.
Features and benefits of the MSM317
The MSM317 is purpose-built for cost-effective, high-density deployments focused on quality of experience. Key
features include:
Converged wired/wireless solution
•
Dedicated service per room
•
Simplified installation—single cable for voice, video, and data
•
Mounts in standard electrical wall box
•
802.11 b/g access point
•
4-Port, 10/100 managed switch
•
Powered by 802.3af or 802.3at PoE
•
Single PoE port
•
Centralized configuration and management through MSM7xx Controller*
•
LLDP-MED for automatic IP phone configuration at switch port
•
Quality of Service (QoS) and rate limiting for delivery of latency-sensitive applications
•
Loop protection at switch ports
•
Pass-through RJ-45 connection for support of legacy devices
•
Bulk moving of devices between groups using controller interface
•
Note:
* The MSM317 is a controlled-mode only device. Use of an HP MSM7xx
Controller is required to configure it.
3