HP MSM313 Quick Start

Hide thumbs Also See for MSM313:

Download this manual

The MSM313 is a Wi-Fi Alliance authorized Wi-Fi CERTIFIED 802.11a/b/g product.

The Wi-Fi CERTIFIED Logo is a certification mark of the Wi-Fi Alliance. The MSM313

is certified under the SpectraLink Voice Interoperability for Enterprise Wireless

(VIEW) Certification Program.

VIEW

Certified

MSM313 Integrated Services Access Point Quickstart

This Quickstart introduces the MSM313 (US J9346A/B, WW J9350A/B) Integrated Services Access Point and shows you how to get started using it. After

following the directions in this Quickstart, see the HP MSM313/MSM323 Management and Configuration Guide available at: www.hp.com/networking/support.

Hardware overview

Package contents

MSM313, two 2.4-GHz (2-dBi) / 5-GHz (2-dBi) dual-band omnidirectional antennas,

documentation.

Radio and Antennas

The MSM313 has a single radio with two antennas for diversity.

The antenna connectors are reverse-polarity SMA jacks. Antennas or cable connectors must

use RP-SMA plugs. Antennas can be mounted directly on the MSM313. When a single antenna

is used, it is recommended to attach it to the Main antenna connector.

Ports

•

Ethernet ports: Two 10/100 Mbps Ethernet ports with RJ-45 connectors. Only the LAN

port supports Power over Ethernet (PoE). Ethernet ports are for LAN connections only,

and they have not been evaluated for connection to MAN or WAN applications.

•

Serial port: To connect to a computer, use a standard (straight-through) serial cable

with an RJ-11 connector. For details, see Ports in the HP MSM313/MSM323

Management and Configuration Guide. The RJ-11 connector is not a telecommunication

port and cannot be connected to outside plant leads (phone lines).

Reset button

Press and quickly release the button to reset the MSM313. To reset to factory default

settings, press and hold the reset button until the status lights flash three times, then

release. For details, see Resetting to factory defaults in the HP MSM313/MSM323

Management and Configuration Guide.

Page 1: Hardware Overview
MSM313 Integrated Services Access Point Quickstart This Quickstart introduces the MSM313 (US J9346A/B, WW J9350A/B) Integrated Services Access Point and shows you how to get started using it. After following the directions in this Quickstart, see the HP MSM313/MSM323 Management and Configuration Guide available at: www.hp.com/networking/support.
Page 2: Important Information To Read Before Installing
When mounting the MSM313 on a wall or ceiling, ensure that the surface to which you PROFESSIONAL INSTALLATION REQUIRED. For Indoor installation only. attach the MSM313 and the fasteners you use can support at least .9 kg (2 pounds). Allow WARNING: Prior to installing or using this device, consult with a professional installer extra weight for cables.
Page 3 E. Configure the Internet connection C. Perform these initial login tasks By default, the MSM313 operates as a DHCP client to obtain its IP address from a DHCP Some prompts only appear when the MSM313 is in its factory-default state.
Page 4 On the rev A MSM313, the 5 GHz DFS channels are enabled and can be used. Assigning an IP address • On the rev B MSM313, the following additional 5 GHz DFS channels are disabled and cannot be The Internet port defaults to being a DHCP client. If your Internet service provider or network used: administrator requires a different configuration, for example static IP address assignment, •...