Safety Instruction - Toshiba 55L7400U series Service Manual

Hide thumbs Also See for 55L7400U series:
Table of Contents

Advertisement

WARNING:
BEFORE SERVICING THIS CHASSIS, READ THE "SAFETY
PRECAUTION" AND "PRODUCT SAFETY NOTICE" INSTRUCTIONS BELOW.
Safety Precaution
WARNING:
SERVICING SHOULD NOT BE ATTEMPTED BY ANYONE UNFAMILIAR
WITH THE NECESSARY PRECAUTIONS ON THIS RECEIVER. THE FOLLOWING ARE
THE NECESSARY PRECAUTIONS TO BE OBSERVED BEFORE SERVICING THIS
CHASSIS.
1.
An isolation transformer should be connected in the power line between the receiver
and the AC line before any service is performed on the receiver.
2.
Always disconnect the power plug before any disassembling of the product. It may
result in electrical shock.
3.
When replacing a chassis in the cabinet, always be certain that all the protective
devices are put back in place, such as nonmetallic control knobs, insulating covers,
shields, isolation resistor-capacitor network, etc.
4.
Always keep tools, components of the product, etc away from the children, These
items may cause injury to children.
5.
Depending on the model, use an isolation transformer or wear suitable gloves when
servicing with the power on, and disconnect the power plug to avoid electrical shock
when replacing parts. In some cases, alternating current is also impressed in the
chassis, so electrical shock is possible if the chassis is contacted with the power on.
6.
Always use the replacement parts specified for the particular model when making
repairs. The parts used in products require special safety characteristics such as
inflammability, voltage resistance, etc. therefore, use only replacement parts that
have these same characteristics. Use only the specified parts when the
indicated in the circuit diagram or parts list.
7.
Parts mounting and routing dressing of wirings should be the same as that used
originally. For safety purposes, insulating materials such as isolation tube or tape are
sometimes used and printed circuit boards are sometimes mounted floating. Also
make sure that wirings is routed and clamped to avoid parts that generate heat and

SAFETY INSTRUCTION

(1/3)
mark is

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents