Special Functions; Clean Washer - Kenmore 796.4116 Series Use & Care Manual

I SPECIAL FUNCTIONS
CONTROL LOCI(
] Use this option to disable the controls.
@ Control LockJ_ The washer can only be locked during
J
a cycle. This feature can prevent
children from changing cycles or
operating the machine. Once set, the controls remain locked
and Control Lock must be turned OFF before the controls
can be used again. Once the washer has shut off, the power
button will allow the machine to be turned ON, but the
controlswill still be locked. When the controls are locked,
the Control Lock LED will illuminate and "CL" will display
alternately with the estimated time remaining.
To activate the Control Lock, press and hold the
CONTROL LOCI( button for three seconds.
CLEAN WASHER
I 1 Detergent residue can build up in the
@ Clean WasherJ wash drum over time and can lead to a
mildewy or musty smell. The Clean
Washer cycle is specially designed to
remove this buildup using bleach or another cleaner designed
specifically for cleaning front load washers. Run the Clean
Washer cycle once a month, or more often under heavy use
conditionsor if odor is present. See complete instructions in the
CARE AND CLEANING section.
l urn ON the washer and press the CLEAN WASHER
button. Selecting any other cycle after Clean Washer has
been selected will cancel the Clean Washer cycle.
O Fill the bleach the MAX line with
dispenser to
liquid
chlorine bleach. Do not overfill the bleach dispenser.
Overfilling will cause the bleach to dispense immediately.
NOTE: For other drum cleaning products, follow
the cleaner manufacturer's instructions and
recommendations. For powdered cleaning products,
add the cleaner to the main wash compartment of
the dispenser drawer. Place tablet cleaners directly
into the drum.
Press the START/PAUSE button to start the cycle.
After the cycle has ended, secure the door slightly ajar
with the door magnet. This will promote air circulation
and allow the interior of the machine to dry. To use this
feature, close the door just until it contacts the door
magnet.
NOTE: Do NOT use this cycle with clothes, and do
NOT add detergent or fabric softener.
AUTO SOAK
Use the Auto Soak option to presoak
[@ AutoSoak ] garments to help remove difficult
spots or stains on fabric. This option
provides a 30 minute presoak prior
to the start of the selected cycle. At the end of the
presoak time, the selected cycle will use the same water.
22