Samsung AM0 SERIES Installation Manual page 36

13. Setting SEG16, SEG17 option
Press Low Fan button( ) to enter SEG16 value.
Press High Fan button( ) to enter SEG17 value.
Each time you press the button,   ...  will be selected in rotation.
14. Setting Dry mode
Press Mode button to be change to Dry mode in the OFF status.
15. Setting SEG18, SEG20 option
Press Low Fan button( ) to enter SEG18 value.
Press High Fan button( ) to enter SEG20 value.
Each time you press the button,   ...  will be selected in rotation.
16. Setting Fan mode
Press Mode button to be change to Fan mode in the OFF status.
17. Setting SEG21, SEG22 option
Press Low Fan button( ) to enter SEG21 value.
Press High Fan button( ) to enter SEG22 value.
Each time you press the button,   ...  will be selected in rotation.
18. Setting Heat mode
Press Mode button to be change to HEAT mode in the OFF status.
19. Setting SEG23, SEG24 mode
Press Low Fan button( ) to enter SEG23 value.
Press High Fan button( ) to enter SEG24 value.
Each time you press the button,   ...  will be selected in rotation.
Step 3. Check the option you have set
After setting option, press


Step 4. Input option
Press operation button
For the correct option setting, you must input the option twice.
Step 5. Check operation
1. Reset the indoor unit by pressing the RESET button of indoor unit or outdoor unit.
2. Take the batteries out of the remote controller to exit programming mode and insert them again and then press
the operation button.
AM0**JNZDCH/AA IM ENG_V1.5_07082015
Option setting
button to check whether the option code you input is correct or not.
 
 
with the remote control pointed at the AHU PCB (power must be applied to the AHU).
 

35
Status
SEG16 SEG17
SEG18 SEG20
SEG21 SEG22
SEG23 SEG24