Contents Welcome Power Plantronics Software Install Plantronics Hub Start Hub Hub Tabs Use your headset Answer, end and make calls Put a call on hold Adjust volume Mute a call Troubleshooting...
Welcome Congratulations on purchasing your new Plantronics product. This guide contains instructions for setting up and using your Plantronics DA USB Audio Processor. Please refer to the safety instructions for important product safety information prior to installation or use of the product.
To start Hub, click Start > Programs > Plantronics > Hub Hub Tabs When you first start Plantronics Hub the About Tab will be displayed. If you have at least one Plantronics device connected to your computer using a USB connector you will see an image of your device along with some information about that device.
If your softphone is not currently supported by Plantronics Software, answer/end via pressing the call button on the headset will not function; you must answer the call from the softphone interface. Put a call on hold If your softphone has this feature, holding down the answer/end button for 2 seconds will place the call on hold.
Be sure your PC is in an active state. headset call button.) • Be sure you have the Plantronics software installed. I cannot hear the caller. • The USB audio processor is not set as the default audio device. Use the audio setting in Windows under Sounds and Audio Devices to select the correct USB audio processor (DA70/DA80/DA90) as the audio device.