Siemens gigaset SE551 User Manual page 30

Gigaset SE551 WLAN dsl/cable / multilanguage / A31008-M1029-R101-2-Z143 / qig_Gigaset551.fm / 03.07.2006
Quick Start Guide
Configuring the Gigaset SE551 WLAN dsl/cable
You now need to make a few configuration settings so that you can use your Gigaset
SE551 WLAN dsl/cable to operate a local network and establish a connection to the
Internet. The Gigaset SE551 WLAN dsl/cable provides you with a user interface which
you can open with a web browser. Now carry out the following steps:
ì
Launch the web browser on your PC.
ì
Enter the IP address of the Gigaset SE551 WLAN dsl/cable in the browser's address
field:
http://192.168.2.1
A Web page appears for you to enter a password. As supplied, the default password is
admin admin.
ì
Enter the password and click on OK.
You will now see the start screen.
Please remember:
For security reasons you should change the password at a later stage (refer to the user
guide on the CD supplied).
ì
Click on OK.
You will now see the start page.
ì
Click on Basic Setup Wizard.
ì
Confirm the welcome page with Next >.
ì
Select your current location. You can make the settings for the clock to change auto-
matically to summer time and/or to the time zone as you wish.
ì
Confirm your entry with Next >.
ì
Select your Internet service provider and enter in the fields the access data that you
have received from your Internet service provider.
ì
Select the way your Internet connections are to be established:
– Select Always on if the connection is to exist at all times when the Gigaset SE551
WLAN dsl/cable is switched on.
– Select Connect on demand if applications such as a web browser or an e-mail
program are to connect to the Internet automatically.
– In the Idle time before disconnect field, enter a period of time after which the
Internet connection is to be automatically ended if no data is transmitted (default
setting: 3 minutes).
You can deactivate this function by entering "0". This means that the connection
will continue to exist even if no data is transmitted. If you have a time-based tariff
this can cause high charges. In this case you should enter a value other than "0".
This time setting only applies to the Connect on demand option.
26