Table of Contents
Advertisement
HOLD Button
HOLD Button
This feature allows you to place a call on hold.
To place or retrieve a call on hold:
1. While on an outside line call, press [HOLD] to place the
call on hold.
2. Press [HOLD] again to retrieve the call.
To place an outside call while on hold:
1. Press [HOLD].
2. Press [ON/OFF] to enter idle mode.
3. Press [ON/OFF] again, listen for dial tone. Place the
outside call.
4. Press [ON/OFF] to end the call and enter idle mode.
5. Press [HOLD] to retrieve the call on hold.
To switch calls from the Wanderer to the telephone:
1. Press [HOLD] to place the call on hold.
2. Press [ON/OFF].
3. Pick up the call by pressing the flashing, outside line, loop
or intercom button on the telephone.
To switch calls from the telephone to the Wanderer:
1. Place the call on hold at the telephone.
Make sure [ON/OFF] button is not lighted and the
handset is in cradle.
2. Press [ON/OFF] on the Wanderer.
3. Press [HOLD] to pick up the call on the Wanderer.
To process multiple calls from your Wanderer:
1. Press [HOLD] to place your call on hold. An intercom dial
tone is heard.
2. Dial an intercom number or a trunk group access number
to be connected to a second call.
If [HOLD] is pressed while on the second call, it is ignored.
Using Your New Wanderer
9
Advertisement
Table of Contents
