Fujitsu PRIMEQUEST 2000 Series Configuration Manual page 8

Notes at System Operation
At the time of system operation, consider the following points.
 Before restart of your server, make sure that SAN storage devices and FCoE switch are ready to use.
 Until the partition is powered on, you can use MMB Web-UI to configure the partition.
 In a case as such a hardware failure occurs, the suspected unit may not be identified by temporary
analysis on event logs.
 Record the date and time of replacing the server (including replacing or relocating the CNA).
 If you replaced the CNA with spare part, you have to reconfigure UEFI/extended BIOS on your server.
And you have to reconfigure FCoE switch/SAN storage device.
 In SAN boot environment, depending on the quality condition of FCoE transmission path, the OS boot
may be fail. In this case, administrator checks the alarm and the status of the system, and identifies
the suspected unit in the FCoE switch and SAN storage device. In addition, select [Reset] in [Power
Control] screen of the MMB Web-UI, and then restart the server.
 In Linux environment, if you use SAN boot with multi-path configuration, in order to do auto mount the
disk of ETERNUS in Rescue Mode, make only one FCoE port enabled(linked), and boot from the port.
 As a multi-path configuration, it may not be able to start up properly.
 In addition, in order to avoid mistake of operation, even if you do not do auto mount, it is recommend
that you make only one FCoE port enabled(linked) and boot from the port in Rescue Mode.
Setting of Connection of ETERNUS
For more information about configuration which is required to connect ETERNUS, refer to the following
Web site.
http://storage-system.fujitsu.com/jp/catalog/manual.html
Copyright 2016 FUJITSU LIMITED 8 CA92344-0966-01