Philips FC9256 Service Manual page 3

REPAIR INSTRUCTION
- Appliances from before WK845 have a potential problem
in the cord winder system; the lever of spindle (Pos. 24) can
move out of position.
Symptom:
Cord will not rewind pressing the cord winder button.
Solution:
Remove the Cord winder button as shown in below picture:
Remove the cord winder button by simultaneously operating
the button and putting a screwdriver between the openings
that occur.
Then lift the button by levering the screwdriver.
This has to be done at 2 (two) positions as indicated in the
picture.
Insert a screwdriver (size 1) in the position as shown in below
picture and move it backwards until a "Click" is heard, the
lever of spindle is now back in position. This can be tested by
pressing lever A, the cord should rewind now.
"Click"
A
To prevent lever shifting out of position to re-occur,
CW support (Pos. 68) must be added as shown in below
pictures:
Rotate the part 90 degrees CCW, once it is inside the housing
half way.
Then drop the part till it is completely inside the appliance
and push down with a screwdriver untill "Click".
Finally re-assemble the button.
Press it fi rmly, until the "Click".
FC9256
90° 90° 90°
CCW CCW CCW
"Click" "Click" "Click"
3-8