Nikon CP4200 Owner's Manual page 23

The Button
The camera can also be turned on by pressing the
Your most recent picture will be displayed in the monitor (
The Power-On Lamp
The power-on lamp indicates the following:
When the power-on lamp is
Blinking
Auto Power Off (Standby Mode)
If no operations are performed for one minute (default setting), the monitor will turn
off automatically and the camera will enter standby mode to reduce the drain on the
battery. While the camera is in standby mode, the power-on lamp will blink. If no op-
erations are performed for three minutes after the camera enters standby mode, the
power will turn off automatically and the power-on lamp will go out. The camera will
be reactivated from standby mode when you:
• Press the power switch
• Press the shutter-release button halfway
• Press the button to view the last picture taken
• Press the MENU button to display the menu for the current mode
• Rotate the mode dial to select a new mode
The length of time before the camera enters standby mode can be changed using the
Auto off option in the setup menu (
menu is displayed, the monitor will turn off after three minutes, and when pictures are
being shown in a non-stop slide show (
AC adapter kit, the monitor will turn off after thirty minutes.
When connecting the camera to a computer or printer with a USB cable, Auto power
off function does not work.
On
Off
button for about two seconds.
The camera is
In standby mode
119). However, when a menu or the setup
97) or when the camera is powered by an
53).
On
Off
13