Hitachi C 12LSH Technical Data And Service Manual page 9

Cutting position can be easily adjusted because the laser line can be aligned with an optionally angled ink
3
line.
Even the workpieces such as crown moldings and base boards that have decorative surfaces and are
4
difficult to be made an ink line can be cut just by aligning the laser line with the ink line on the fence side.
The laser line is adjusted to the width of the saw blade at the time of factory shipment. Depending upon the
user's cutting choice, the laser line can be aligned with the left side of the cutting width (saw blade) or the
ink line on the right side. Adjust the position of the laser line according to "8-4. Position Adjustment of Laser
Line" on page 23.
(4) Miter and bevel angle fine adjustment
The Model C 12LSH and C 12RSH are easily and finely adjustable to an optional miter and bevel angle.
Loosen the side handle and turn knob (A) while pulling up the lever to adjust the miter angle finely (Fig. 7).
Loosen the clamp lever and turn knob (B) to adjust the bevel angle finely (Fig. 6).
(5) High sub fence
The Models C 12LSH and C 12RSH have a high sub fence (right and left). Use the high sub fence for miter
cutting, left and right bevel cutting or crown molding cutting. The high sub fence supports the workpiece
widely for stable cutting.
Maker
Model
Height
of fence
A Left 50 (1-15/16")
B Left
Fixation
fence
C Left 120 (4-11/16")
E Right 45 (1-3/4")
Left 120 (4-11/16")
D
(Rotary type)
High sub
Right 120 (4-11/16")
fence
F
(Rotary type)
Fig. 4-b
HITACHI
HITACHI
C 12LSH
C 12FSA
C 12RSH
Left 49 (1-15/16")
Left
Left 70 (2-3/4")
Right 30.5 (1-3/16")
Left none
Right none
Table 2
C
Left 45 (1-3/4")
Left 80 (3-3/16")
Left 115 (4-1/2")
Right 30 (1-3/16")
Left 115 (4-1/2")
(Rotary type)
Right none
--- 5 ---
Fig. 4-c
Unit: mm (inch)
P
Left 29 (1-1/8")
Left
Left
Right 29 (1-1/8")
Left 109 (4-5/16")
(Horizontally movable type)
Right 109 (4-5/16")
(Horizontally movable type)