Advertisement
Another way to select a temporary hold is:
1. Press SELECT
until the cursor is over TEMP H0LD. Press SET.
The temperature
will be blinking. Use the A or V button to change
the tem0erature.
2. Press SET.
To cancel a temporary hold, press SELECT
until the cursor is aoove
RUN/SET
PR0G. Press SET.
Vacation l'lold
You can setyourthermostatto
hold a desired temperature
for 1-365 days.
Vacation hold terminates at midnight of the last day. The thermostat
returns to normal operation the next day at 12:01 AM.
1. Press SELECT
until the cursor is over VAC H0LD. Press SET. The
temperature
will be blinking. Use the A or V button to change the
temperature.
2. Press SET. 7d will be displayed. Use the A or V button to adjust
between 1 and 365 davs.
3. Press SET.
To cancel a vacation hold. oress SELECT
until the cursor is above
RUN/SET
PR0G. Press SET.
Check Filter Reset
0nce the filter timer has expired,
CHECK FIITER will turn on and stay
:
o n . T o c l e a r t h e m e s s a g e a n d r e s e t t h e
c H E c K F T L T E R
trmer:
I
1. Press SELECT
and SET and hold for
3 seconds. C[r will aooear in the
time display.
2. Press any key to clear the message.
The display willtransition
to the tem-
perature scale display. See step 4 in
CUSTOMIZING
YOUR THEBMOSTAT.
3. No further input is needed- Within a
return to the normal operating mode.
f e w s e c o n d s , t h e d i s p l a y w i l l
Reset
The BESET button is located above the upper left corner ofthe display.
0nly use the reset feature if the thermostat is malfunctioning.
BESET
BUTTON
lf problems with thermostat cannot be resolved, call:
Technical SupporL (800) 445-8299
Monday-Friday
7:30-5:30
CST
For after hours service, a 24-hour
automated helo line is available.
For warranty returns,
send thermostat,
shipping
prepaid to:
Climate Controls Americas
Warranty Department
515 South Promenade
Avenue
C o r o n a . C A 9 1 7 1 9
TWO.YEAR TIMITED WARRANTY
Climate Controls Americas warrants to the original contractor
installer or to the original consumer user, each new Robertshaw
thermo-
stat to be free from defects in materials and workmanshio
under normal
use and service for a period of two (2) years from date of purchase. This
warranty and our liability does not applyto batteries or merchandise
that
has been damaged by misuse, neglect, mishandling,
alterations,
improper
installation,
or use in a wav other than in accordance with Climate
Controls Americas recommendations
and instructions.
Climate Controls Americas agrees to repair or replace at its option
any thermostat under warranty provided it is returned within the warranty
period, postage prepaid, with proof of the date of purchase. Cost of ther-
mostat removal or reinstallation
is not the responsibilitv
of Glimate
Controls Americas.
Repair or replacement
as provided under this warranty is the exclusive
remedy of the consumer.
Climate Controls Americas shall not be liable
for any incidental or consequential
damages for breach of any express or
implied warranty on this product, or under any othertheory of liability.
Exceptto the extent prohibited by applicable law, any implied warranty of
merchantability
or fitness for a particular purpose on this product is limit-
ed to the duration of this warranty.
Some states do not allow the exclusion or limitation of incidental or con-
sequential damages, or allow limitations
on how long an implied warranty
lasts, so the above limitations
or exclusions
may not apply to you. This
warranty gives you specific legal rights, and you may also have other
rights which vary from state to state.
InvgnSyS.
Climate Controls Americas
191 E. North Avenue
Carol Stream. lttinois 601 88
United States of Amenca
O2004 Climate Controls Americas
1 2
Troubleshooting
symptom
Remedy
Thermostat does not turn
on system.
Check wiring.
(See Installing lrem 8625
Themostat)
Thermostat turns on and off too
freq uently.
Increase temoerature
differential.
{See Programming Guide}
System fan does not operate
properly.
Move the Electric/Gas
switch to
either gas or electric, to match
system. (See Installing ltem
8625 Thermostat)
llme shown on display is not the
current time of day.
C h a n g e t i m e o f d a y s e t t i n g .
{See Programming Guide}
t
-l
Thermostat does not
follow program.
Thermostat
may not have been
programmed
in HEAT or C00L
position. Verify program.
Check AM/PM indicators at time
of day and programmed
time
cna nges.
(See Programming Guide)
Verify program and day of week
are correct
(See Programming Guide)
l L ' -
10
Advertisement
