Snooze Function; Aux-In Function - Roadstar HIF-3650UMP Instruction Manual

5. Repeat step 3 & 4 for setting Month, Date, 12/24Hr, Hour and Minute
ALARM SETTING
ALARM setting must be after completed clock setting. Unit must be in "STANDBY "
mode.
Below is using "AL 1" alarm setting for example:
1. Press and hold the "AL 1" button for 2 seconds to entry alarm set mode.
2. Adjust hour by pressing the "SKIP+" (8) or "SKIP-" (9) button, press the "AL 1" button to
confirm.
3. Adjust minute by pressing the "SKIP+" or "SKIP-" button, press the "AL 1" button to confirm.
4. Press the "SKIP +" (8) or "SKIP -" (9) button to select below 1, 2 .3 or 4 for wake-up function:
1 - FM
2 - MP3 (DISC)
3 - USB
4 - BUZZ
5. Press the "AL1" button to confirm. The display will show "AL1", ALARM set is complete.
6. Press the "AL1" button to activate alarm ON/OFF function.
7. When "AL1" is OFF, "AL1" will disappear from the display.

SNOOZE FUNCTION

SNOOZE must be after completed ALARM setting. When the timer is triggered. You may
press the "SNOOZE" button to delay the alarm fr another 10 minute

AUX-IN FUNCTION

1. Use a 3.5mm Male-to-Male Stereo cable to connect any external audio device with a 3.5mm
Headphone or Line-Out jack to the AUX IN jack on the front panel of the stereo.
2. Start playback on the external audio device. Adjust the volume on the audio device (do not
set the volume too high to avoid distortion). You may also adjust the volume on the appliance.
3. To control playback function, use the controls provided by the external audio device.
ATTENTION!
THIS PRODUCT IS ALSO ABLE TO REPRODUCE CD-RW DISCS, HOWEVER IT COULD
HAPPEN THAT DURING PLAYBACK SOME TYPE OF DISCS CANNOT BE PLAYED
PROPERLY. THEREFORE, FULL PLAYABILITY WITH ALL CD-RW DISCS IS NOT
GUARANTEED.
HANDLING COMPACT DISC
• To remove a disc from its storage case, press down on the centre of the case and lift the
disc out, holding it carefully by the edges.
Fingerprints and dust should be carefully wiped off the disc's recorded surface with a soft
5
English
6
English
cloth. Unlike conventional records, compact discs have no grooves to collect dust and
microscopic debris so gently wiping with a soft cloth should remove most particles. Wipe in
a straight line from the inside to the outside of the disc. Small dust particles and light stains
will have absolutely no effect on reproduction quality.
• Never use chemicals such as record sprays, antistatic sprays, benzine, or thinners to clean
compact discs. These chemicals can irreparably damage the disc's surface.
• Discs should be returned to their cases after use. This avoids serious scratches that could
cause the Laser pickup to skip.
• Do not expose discs to direct sunlight, high humidity, or high temperatures for extended
periods. Long exposure to high temperatures can warp the disc.
• Do not stick paper or write anything with a ballpoint pen on the label side of the disc.
COMPACT DISC / USB OPERATION
LOADING AND UNLOADING COMPACT DISCS
• Set the Function Selector (11) to the CD /USB/SD Position.
• Open the disc compartment by pressing on the CD OPEN right corner.
• When the disc compartment has opened, remove a disc from its case and place it carefully
in the compartment with the label side facing up. Locate smaller, 3" discs, in the centre
depression of the compartment.
• Close the disc compartment.
When the compartment is fully closed, the disc will start turning automatically. The total
number of tracks of the CD will appear on the LCD display (3).
CAUTION
• Do not put anything except a compact disc into the compartment. Foreign objects can
damage the mechanism.
• Keep the disc compartment closed when not in use to prevent dirt and dust from entering
the mechanism.
• Never place more than one disc into the disc compartment at any time.
• If the disc is correctly loaded , the following information will be displayed:
Total number of tracks on the disc
Notes: After the disc compartment is fully closed, the disc information may not appear on the
display, This means that the disc is improperly loaded (most likely it is upside down). To
check, open the disc compartment again and reload the disc.