Location Of Controls; Clock Setting - Roadstar HIF-3650UMP Instruction Manual

LOCATION OF CONTROLS

1. Power cord
2. Antenna FM
3. LCD Display
4. USB Port input
5. volume up /Alarm 1
6. volume down / Alarm 2
CD/USB Play /Pause- Button
7. (II)
CD/USB Forward Skip/Search Button
8.
9. CD/USB
skip button
10. Tuning Control
11. Function Selector (RADIO/USB/CD/AUX)
12. Remote sensor
13. Mode Display / Clock / Repeat / Program Button
14. Album button
15. CD Open corner
16. Left Speaker (L)
17. Right Speaker (R)
18. AUX-IN
19. Eadphone output
20. Snooze button
CONNECTING TO POWER
Before switching on make sure that the voltage of your electricity supply is the same as that indicated
on the rating plate.
For your own safety read the following instructions carefully before attempting to connect this unit to
the mains.
MAINS (AC) OPERATION
This unit is designed to operate on AC 230V 50Hz current only. Connecting it to other power sources
may damage the unit.
CAUTION
To prevent electric shock disconnect from the mains before removing cover. No user serviceable parts
inside. Refer servicing to qualified service personnel.
SAFETY PRECAUTION
Do not allow this unit to be exposed to rain or moisture.
Mains Supply: 230V 50Hz - AC only
This symbol means that this unit is double insulated. An earth connection is not required.
English 3 4 English
POWER SUPPLY
Remove the stereo carefully from the box, retaining the packaging for future use.
AC POWER OPERATION
Connect the plug to a mains power inlet 230V AC ~ 50 Hz.
CONNECTIONS
SPEAKER CONNECTION
Connect each speaker to the corresponding speaker terminals (16 / 17) on the back of the system.
Ensure that the left speaker is connected to the left terminals, and the right speaker to the right terminals.
MW/FM TUNER
OPERATION
• Press the Function Selector sequentially (11) until the RADIO AM or FM compare in the
display.
• Tune to the desired radio station by turning the Tuning control (10).
• To POWER OFF press the Function Selector (11) three seconds.
ANTENNA
• For FM reception there is a built-in FM antenna wire at the rear of the unit (2). Move the wire
around to obtain the best reception.
• For MW reception the signals are picked up through a built-in ferrite antenna. Your may have
to orient the unit to obtain the best reception.
FM-STEREO RECEPTION
• Stereo reception is possible when the tuned FM station is broadcasting in stereo.
• When in FM mode and the station is broadscasting in Stereo, the STEREO indicator compare
in the display.

CLOCK SETTING

1. Make sure the unit is in standby mode.
2. Press and hold "CLOCK SET" (13) button until the unit entered the year setting.
3. Press "SKIP +" (8) or "SKIP -" (9) to select the desired year.
4. Press "Clock Set" (13) button once to confirm