Remote Control Effective Range; Installing Or Replacing Batteries - BenQ PB8230 User Manual

SALE on Projector Bulbs at www.BulbAmerica.com
take additional 5% Off with coupon code 5PDF

Remote control effective range

The remote sensors are located on the front and the back of the projector. It can
function in a range of 30 degrees horizontally and 30 degrees vertically relative to a line
that is a right angle to the remote sensors. The distance between the remote control
and the remote sensors must be shorter than 6 meters (19.5 feet).

Installing or Replacing Batteries

Push and slide the
1
battery
compartment lid in
the direction shown.
Caution
Avoid excessive heat and humidity. There may be danger of an explosion if
batteries are incorrectly replaced. Replace only with the same or equivalent
type recommended by the manufacturer. Dispose of used batteries accord-
ing to the manufacturer's instructions.
BenQ PB8230/ PB8220/ PB8120 User's Guide
Install batteries as
2
indicated by the
diagram inside the
compartment.
Position the lid
3
over the
compartment and
snap it back into
place.
Introduction
9