Panasonic DMR-EZ47VP Service Manual page 29

7.2.4.2. (VHS) Condition for clearing the self-diagnosis history
1. A case of that press the STOP key and the EJECT key simultaneously over 5 seconds.
7.2.4.3. (VHS) Indication of the self-diagnosis history.
1. The self-diagnosis histories and its supplementary data could be indicated on the FIP with Service mode of number from 3 to
5.
2. The procedure of setting the service mode and the format if the indication are same as usual.
Both the Error numbers and its supplementary data of history 1, 2and 3 are indicated by selecting the Service mode 3, 4 and 5 as
shown above.
In case of that any Error has not been memorized, the Error number and its supplementary data is indicated as " - ".
7.2.4.4. (VHS) Display of Supplementary Data 3 and 4
During displaying the Self-Diagnosis History, press [STOP] key on front panel to change the display.
*Example of Display
A: Service Mode Number.
B: Supplementary Data 3...Mechanism process shifting Number.
C: Supplementary Data 4...LM(Loading Motor information)
*Display of
occurred while mechanism was between REV position and LOAD position.
<Supplementary Data 3>
[EJECT]
10: PLAY → passing REV
11: passing REV
12: passing REV → LOAD
(Capstan STOP)
13: LOAD → DOWN
14: DOWN → EJECT
15: EJECT completion
[PLAY]
20: Cylinder starting up, Phase drawing
21: Audio muting, VV selection
[P.ON]
-- Process of turning on power
[P.OFF]
70: PLAY → P.OFF
means that " Loading Motor turns ON when [EJECT] button was pressed, but an error has
[FF]
U0: PLAY → STOP F
U1: STOP F → FF
U2: FF starting up
[REC]
30: Cylinder starting up, Phase drawing
31: REC signal output
[STILL → PLAY]
48: Tape sending
[CUE → PLAY]
4A: Finishing edge Checking, Tape sending
4-: PLAY Checking, Tape sending
29
DMR-EZ47VP / DMR-EZ475VP
[REW]
A0: PLAY → STOP F
A1: STOP → REW
A2: REW starting up
[STILL]
40:Turning forward
41:Speed is 0, Capstan is OFF
[CUE]
49: x2 speed sending, Turning point of
Calculating remains
[REV]
80: PLAY → P.OFF
81: Rewinding
P.OFF → REV