Pfaff Creative Sensation Pro II Owner's Manual page 51

Dynamic spring foot 6D for embroidery is active by
default when you turn on the machine.
The Dynamic spring foot 6D is always
recommended for embroidery. If another type
of foot is used, e.g., presser foot 6A, deactivate
Dynamic spring foot 6D for embroidery. When
deactivated, the ActivStitch Technology feature
™
will use thread tension instead of thread metering.
In most cases, you do not need to adjust the presser
foot pressure. Specialty techniques may require
an adjustment. The higher the number the more
pressure on the fabric.
Adjust the height of the presser foot in Embroidery
stitch-out mode. Use the + and - icons to either raise
or lower the height of the presser foot.
E F
Some embroideries may build up under the presser
foot. If there is not enough space between the
presser foot and the embroidery, the top thread will
form loops on the underside of the embroidery.
Increase the presser foot height in small steps until
the embroidery moves freely under the presser foot.
Note: Because the Dynamic spring foot 6D measures the
fabric thickness continuously during embroidery, the
option to adjust presser foot height in embroidery is only
available if Dynamic spring foot 6D for embroidery is
deselected.
3:13