Engine Stop Switch; Cable Clamp - Yamaha 2002 YZ250FR Assembly Manual

1 Hot starter (choke) lever 1
2 Boot 1
1 Engine stop button 1
Panhead screw with
2 1
spring washer
Engine stop button
3 2
holder (Upper and lower)
1 Handlebar clamp 2
*
*
*
V d=3 (0.12), l =14 (0.55)
V
V
- 8 -
EAA00198
9. HOT STARTER (CHOKE)
CABLE
A: Install the boot to the hot
starter (choke) lever.
B: Lubricate the pivoting part of
the hot starter (choke) lever.
Recommended lubricants:
Yamaha cable lube or
motor oil
C: Insert the cable end into the
lever hole, then squeeze the
lever.
While pulling the outer cable
in the direction opposite to the
lever, release the lever quick-
ly.
EAA00207

10. ENGINE STOP SWITCH

A:
W
Proper cable and hose routing
are essential to assure safe
motorcycle operation. Refer to
"CABLE ROUTING".
EAA00128

11. CABLE CLAMP

A: Secure the engine stop switch
lead with a cable clamp.
NOTE:
D The cable tie should be
installed according to the
dimensions shown.
D Refer to "CABLE ROUTING".
While releasing the lever, seat
the outer cable into the lever
holder.
NOTE:
Check the hot starter (choke)
lever for smooth action. Refer to
"ADJUSTMENTS AND PREDE-
LIVERY SERVICE".
W
Proper cable routing is essen-
tial to assure safe machine
operation. Refer to "CABLE
ROUTING".