EAM20181
INSTRUMENT AND CONTROL
FUNCTIONS
EAM30182
ENGINE STOP SWITCH
The engine stop switch "1" is located on the left
handlebar. Continue pushing the engine stop
switch till the engine comes to a stop.
EAM30183
START SWITCH
The start switch "1" is located on the right han-
dlebar. Push this switch to crank the engine with
the starter.
1
EAM30384
LAUNCH CONTROL SWITCH
The launch control switch "1" is located on top of
the right handlebar.
When the launch control switch is pressed, the
ignition timing is delayed to reduce slipping at
the rear wheel which occurs when the vehicle
accelerates from a stationary position.
This can be used to starting off in a stable man-
ner on a slippery road surface.
However, the effect may not be adequate de-
pending on the rider's operations and road sur-
face conditions.
INSTRUMENT AND CONTROL FUNCTIONS
1
1-21
1
How to operate
1. Put the gear into the neutral position.
2. Start the engine.
3. Push the launch control switch for more than
one second to turn on the launch control
switch.
TIP
When the launch control switch is turned on, but-
ton "1" will flash.
4. Put the gear into the 1st or 2nd gear for start-
ing off.
5. After starting off, the launch control switch will
turn off automatically when the gear is shifted
into the 3rd gear.
The launch control switch will also turn off when
the engine is stopped or the gear is shifted into
the 3rd gear or higher.
TIP
When the launch control switch is turned off, but-
ton "1" will stop flashing.
1
EAM30471
MODE SWITCH
The mode switch "1" is located on the left han-
dlebar.
Press the mode switch to change between map
1 and map 2.